Applies to:

    - SynetoOS 4.7.0 and above

    - VMware ESXi 6.5 U3 and above


This guide describes how to upgrade your Syneto VMware ESXi to version ESXi-7.0.x


Note:

  • Reverting to a previous build does not revert the tools-light vib version installed on the ESXI host
  • Reverting to an earlier version is not possible after upgrading to ESXi 7.0 due to partition changes to the boot device.
  • To use an earlier version of ESXi after upgrading to version 7.0, you must create a backup of the boot device before the upgrade or reinstall the desired version.


The upgrade requires the host to be rebooted.


Please ensure that you are running SynetoOS 4.7.0 or above before starting the upgrade procedure.


1. Open SSH connection to Syneto ESXi


2. Change directory to your datastore deployment folder (name may vary)

cd /vmfs/volumes/datastore1/deployment


3. Modify firewall rules to be able to download the upgrade bundle

esxcli network firewall ruleset set -e true -r httpClient

4*. ONLY FOR DELL PLATFORMS - MANDATORY

Run the command below

esxcli system module set --enabled=true --module=vmw_ahci

4. Download Syneto VMware ESXi 7.0.x

wget -O esx-syneto-update.zip https://92f0dbb11de5784083aa-bb969871c94ac78f108e561fc9f42b57.ssl.cf5.rackcdn.com/SynetoOS/ESXi-Ugrade-Bundles/ESXi-7.0U1d-17551050-Syneto-v7.180-release.zip

NOTE: Make sure there're no firewall rules or antivirus blocking the connection.
Download MD5 Checksum


5. Update

esxcli software vib install -d /vmfs/volumes/datastore1/deployment/esx-syneto-update.zip

Output

Installation Result
   Message: The update completed successfully, but the system needs to be rebooted for the changes to be effective.
   Reboot Required: true


6. Reboot

reboot


7. Check version after reboot

esxcli system version get
Output
Product: Product: VMware ESXi
   Version: 7.0.1
   Build: Releasebuild-17551050
   Update: 1
   Patch: 30