Applies to: SynetoOS 4.3.0 + its next versions
Using this guide you will upgrade any current hypervisors to the latest Syneto VMware ESXi 6.7. The update requires host to be rebooted.
Please ensure that you are using at least SynetoOS 4.3.0 before running this upgrade procedure. Having the latest SynetoOS is always recommended.
Here are the steps:
Step 1. Clear old configuration for local.sh
echo "#!/bin/sh" > /etc/rc.local.d/local.sh echo "exit 0" >> /etc/rc.local.d/local.sh
Step 2. Browse to your deployment folder from local datastore: (Local datastore name may vary):
Step 3. Modify firewall rules:
esxcli network firewall ruleset set -e true -r httpClient
Step 4. Set Intel drivers to native (required for this upgrade):
esxcli system module set --enabled=true --module=igbn
Step 5. Download latest version from our servers to local datastore:
wget -O esx-syneto-update.zip http://b26e8c3d695ed0fb0dee-bb969871c94ac78f108e561fc9f42b57.r19.cf5.rackcdn.com/SynetoOS/ESXi-Ugrade-Bundles/ESXi-6.7.0-20191204001-Syneto-v5.105-release.zip
Note: Please make sure that firewall/antivirus does not block/filter the connection.
Step 6. Update:
esxcli software vib install -d /vmfs/volumes/datastore1/deployment/esx-syneto-update.zip
Note: Check the output installation for a successful installation:
Installation Result Message: The update completed successfully, but the system needs to be rebooted for the changes to be effective. Reboot Required: true
Step 7. Change acceptance level
esxcli software acceptance set --level=PartnerSupported
Step 8. Reboot:
Final step. Check version after reboot:
esxcli system version get
Output should be:Product: VMware ESXi Version: 6.7.0 Build: Releasebuild-15160138 Update: 3 Patch: 89